posted
so i have a leak coming out from the main needle/LSN i unscrew it and the oring seems fine and no crack on it or no damage on the carb..will putting the high temp gasket maker on the end on the main needle help it from not leaking?
also that my servo lever nut is strip out and it round i cant seem to remove it now its stuck there what will i need to remove it? i tried the star type allen ranch but no luck just wont grip at all..\
thanks
Posts: 7 | From: san diego | Registered: Apr 2008
| IP: Logged
posted
If the main-needle is leaking then it is probably not tightened enough, try to tighten and see if this works, if not you can try and seal it with a little silicone, however do not use too much.
The LSN, you probabaly need to change the o-rings, if not you could try a little silicone.
As for the servo-lever, you proably need to destroy it to replace it for a new one, if you do not feel comfortable with this then please conatct your LHS.
UBBFriend: Email this page to someone!
