RB Concept Forums: E clip or screw

»	RB Concept Forums » RB Concept .23 engines » E clip or screw

UBBFriend: Email this page to someone!

Author

Topic: E clip or screw

KEEBLER
Member

posted

Hey guys whats up. Going to install my RB523 on my revo and wanted to know if I should use the stock Eclip on the CB or should I go with a screw instead.

Posts: 43 | From: Norwalk CT | Registered: Feb 2008 | IP: Logged

RB Products - Rody
Administrator

posted

You can use the stock e-clip as well as the screw, the only think you need to take care of when using the screw is to get the right play when adding the shims, otherwise there will be too much side-play.

--------------------
Do not forget to check out our FAQ section!

Posts: 5386 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

KEEBLER
Member

posted

OK thanks. Do I have to shim the CB if I use just the e clip? If so what size shims do I need? [Smile]

Posts: 43 | From: Norwalk CT | Registered: Feb 2008 | IP: Logged

RB Products - Rody
Administrator

posted

If you use the e-clip you normally do not need to do anything. As for the sizes of the shims 5x8x0.1mm should be O.K.

--------------------
Do not forget to check out our FAQ section!

Posts: 5386 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

KEEBLER
Member

posted

OK Thanks again.

Posts: 43 | From: Norwalk CT | Registered: Feb 2008 | IP: Logged

UBB.classic™ 6.7.2