posted
Have just installed my 323 into the Revo and have a couple of questions
1. The clutch seems to catch on the flywheel and runs a bit tight, has anybody else had this problem?
2. I have a couple of traxass glow plugs left, are these ok to use in the rb?
I'm looking forward to running the engine in and unleashing some power, if anybody has any tips it would be much appreciated
Posts: 4 | Registered: Nov 2005
| IP: Logged
posted
Yeah i had that problem, what i did was, i used the washer that goes behind the C clip, the one that holds the clutch bell on. Take the clip and the washer off, then the clutch bell, then slide the washer on the shaft first then put the clutch bell back on, then just use the C clip on it's own because the washer inside the bell takes up the play! Also my clutch lined up ok doing it this way so it shouldn't cause any problems. Hope this helps
Simon!
[ 29. March 2006, 00:00: Message edited by: Revo 1 ]
Posts: 3 | From: North Wales, UK | Registered: Feb 2006
| IP: Logged
UBBFriend: Email this page to someone!
