RB Concept Forums: rody

»	RB Concept Forums » RB Concept .28 engines » rody

UBBFriend: Email this page to someone!

Author

Topic: rody

rbthereyet
New Member

posted

is this the part number for the backplate?
RB CO1900-120
i want to remove pull starter from tm728 so i can use starterbox.

Posts: 14 | From: FLA | Registered: Jun 2008 | IP: Logged

RB Products - Rody
Administrator

posted

The part# is 01900-122, however it has been discontinued, it could be there are still some around in the shops, try and make a search over the internet.

--------------------
Do not forget to check out our FAQ section!

Posts: 5389 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

rbthereyet
New Member

posted

could i use the tm928 back plate?
or the novarossi.28 backplate?
i will have to trim
the nipple off the crank correct?

Posts: 14 | From: FLA | Registered: Jun 2008 | IP: Logged

RB Products - Rody
Administrator

posted

If you want to use the TM928 backplate you indeed need trim the pin of the crankshaft wich is not easy to do.

--------------------
Do not forget to check out our FAQ section!

Posts: 5389 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

rbthereyet
New Member

posted

i guess there is no other option?

Posts: 14 | From: FLA | Registered: Jun 2008 | IP: Logged

RB Products - Rody
Administrator

posted

Yes, you could change the crankshaft of the TM928 but this will be too expensive in my point of view.

--------------------
Do not forget to check out our FAQ section!

Posts: 5389 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

rbthereyet
New Member

posted

i cannot find the correct backplate(01900-122) anywhere..i will just have to cut the nipple off the crank and use the 928 coverplate.

Posts: 14 | From: FLA | Registered: Jun 2008 | IP: Logged

UBB.classic™ 6.7.2