posted
Dear all, after almost 18 gallons of racing i found out some play in my crank i.e where the conrod goes in. At first i thought the conrod needed to be replaced, so i bought a new conrod tried it and found out to have the same bit of play.
Can any one tell me whats the minimum measuring wear point of the crank
Thanks
[ 17. March 2008, 19:41: Message edited by: speed6 ]
Posts: 25 | From: Malta | Registered: Mar 2008
| IP: Logged
posted
You can find this information on page 2 of the exploded view supplied with your engine. If you have lost this documentation then I suggest you check out the support section of our website.
posted
Yes, this is the size when it is new, I would not continue to use it if it is under 5.33mm You must measure the pin at 2 points with a 90° inteval because it can happen that the pin wears more on one side then on the other.
UBBFriend: Email this page to someone!
