posted
ok i have a 728 with the roto start set up sold the monster truck and want to try it in my truggy so want to put a standard backing plate on it, can i just order a standard backing plate and put it on or do i need to cut the oneway bearing stub off the back of the crank/rod pin before i install the new standard backing plate
Posts: 19 | From: MARYLAND | Registered: Oct 2006
| IP: Logged
posted
I would like some help regarding the size of the BACK PLATE UNIT screws to attach it with the TM728 engine, as I am trying to use the one I have but they appear to be a little smaller in the diameter.
Posts: 4 | From: Malta | Registered: Nov 2007
| IP: Logged
posted
I don’t know but I am trying the 2.5mm screws and they are not tying as suppose. The best I found are 3mm in diameter. They fit very good!
Posts: 4 | From: Malta | Registered: Nov 2007
| IP: Logged
posted
It is not possible to use the M3 screws in the crankcase of the engine where the backplate is situated, you are probably talking about fixing the starter unit on the backplate, since indeed there we use M3 screws.
posted
You’re right! I was saying about the screws for the starter unit not for the backplate to be attached with the crankcase. Sorry my mistake!
Posts: 4 | From: Malta | Registered: Nov 2007
| IP: Logged
UBBFriend: Email this page to someone!
