posted
hello, i have a ? about my new tm928 .i just bought it last week along with the ws7111. as i was breakin them im the tm928 kept shutin off and would not idle. i have new fuel lines ,changed to differnt plug ,os 3 ,os 7 ,rb7 and differnt fuel 20% and 30% trinity .i even installed a new tank .once i got it to idle i am having problems with bogin and seeing temp of 270 -280 i have read all the forum posted and also heard of local racers having the same problems i am in need of help . i know u have great products because i have been racing for year .my ws7111 is runnin great
posted
Have you tryed to lean out the low side needle? And have you tryed a different brand of fuel I did this and my problems went away,odonnel fuel 20%
Posts: 11 | From: connecticut,usa | Registered: Mar 2006
| IP: Logged
posted
If the engines rpm stays high after a high speed run and lowers after a while then the LHS is too rich. Lean it out more and when after the idle stays high, then just lower it by unscrewing the airscrew.
posted
i am going to try leaning out the lhs and give it shot hopefully i can get to work better. about sealin the motor i already did it using rtv ,i was carefull not to use to much so it dont get inside the motor .is that ok or should i clean that rtv off
UBBFriend: Email this page to someone!
![[Roll Eyes]](rolleyes.gif)
i have read all the forum posted and also heard of local racers having the same problems i am in need of help . i know u have great products because i have been racing for year .my ws7111 is runnin great
