posted
its probably me being over eager with the puller but i seem to keep going through them like no tomorrow at the moment. i snapped the origonal in the cold, i snapped the second when the engine was warmed and nearly running. (wanting to run but not quite there) and then on the sime night one i rebuilt using pullswitch cord. again when it was nearly running. luckily Thunder tiger pullers fit but even so its costing me a small fortune. is their anything i can do appart from loosening the plug and grinning and bearing it i can do?
Posts: 16 | From: Oswestry, Shropshire, England | Registered: Jan 2006
| IP: Logged
posted
I suppose the engine is quite new, then have you pré-heated the engine?, it makes the starting easier, especially in the beginning when the piston-sleeve is still tight.
posted
preheat that sucker till its hot and crack the plug open a couple turns until it starts will help!
Posts: 60 | From: Anchorage, Alaksa | Registered: Sep 2003
| IP: Logged
posted
thanks for that, have tried it. unscrewing the plug certainly helps
Posts: 16 | From: Oswestry, Shropshire, England | Registered: Jan 2006
| IP: Logged
UBBFriend: Email this page to someone!
