posted
I have a savage which can barely fit the .25 in the motor mounts. When the .28 (which I preordered) arrives I doubt it will fit. I see in the video you are running it in a savage. What type of motor mount did you guys use. Appreciate the info.
-------------------- NEED INFO, MORE INFO. Posts: 5 | From: Queens, New York | Registered: Apr 2004
| IP: Logged
posted
I just cut the original engine-mounts in 2 and made(cut) a little 45° angle on the inside of the engine-mounts(where the engine has contact) because the quality of these are not very good.
This did the trick and so I could test the TM728, however I guess there must be some aftermarket engine mounts available too.
posted
the force 25 has holes in the wrong place.. so they do not fit a savage mount..
Rody, is it the same bolt pattern as a ws7II for the mounts? if its cast in the same place you may have to champher the edges alittle.. like you need to do for a picco 26 (junk engine) but the bolt holes them selves should not be a issue if they are in the same place.
NOVA has a sweet looking engine mount for a savage also...
posted
Yes, the TM728 has the same bold patern as the .21 engines in our program, however the TM728 is a little wider, that is why you need to cut the original engine mounts in 2
UBBFriend: Email this page to someone!
