posted
What screwdriver tip is the correct size for the engine screws in general.
Is that size the same for the 21 engines as well as the 28's
The carburator needles?? what size tip to use on those
I currently have a 728 and a WS7II.
I think it would be good to list these sizes on the forums somewhere so that people are not stripping those out. I know more than once I have partially stripped a carb needle due to tight seals. Maybe a listing for ALL RB motors
If they are already listed,,then my apologys,,maybe you could direct me to where they are listed.
[ 02. April 2006, 16:58: Message edited by: mydixie ]
Posts: 99 | Registered: May 2004
| IP: Logged
posted
stripping the heads of the screws is not only due to the size but also to the quality of how you position the tool and keep the position while rotating.
UBBFriend: Email this page to someone!
