RB Concept Forums: Front ball bearing after run in.

»	RB Concept Forums » Running in your RB Concept engine. » Front ball bearing after run in.

UBBFriend: Email this page to someone!

Author

Topic: Front ball bearing after run in.

kristof de block
New Member

posted

Hello,

After i runin my new S7 engine there as a lot of fuel in to the car! Now is that normal that the engine is loosing fuel via the front ball bearing?

KInd regards
Kristof

[ 16. April 2008, 15:02: Message edited by: kristof de block ]

Posts: 12 | From: belgium | Registered: Apr 2007 | IP: Logged

RB Products - Rody
Administrator

posted

No it is not really normal that fuel comes from the front-bearing, however are you sure this is the problem?

For example if you leave the fuel in the fueltank and you transport your car in a position that the fuel can run into the engine then it is normal you can have fuel coming out of the front-bearing.

If this is not the case I suggest you contact your LHS from who you have purchased the engine from and aske them to take a look at it.

--------------------
Do not forget to check out our FAQ section!

Posts: 5391 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

kristof de block
New Member

posted

Hello Rody,

Thx for the fast reply !

I will try tomorow again the carbu was mayby not on the right place there was a little space between carbu and engine . But i did the transport with a empty fuel tank!
The carbu and the backplate of the clutch was under the fuel so i will cheq tomorow.

Posts: 12 | From: belgium | Registered: Apr 2007 | IP: Logged

UBB.classic™ 6.7.2