RB Concept Forums: Gearing for break-in

»	RB Concept Forums » RB Concept .12 engines » Gearing for break-in

UBBFriend: Email this page to someone!

Author

Topic: Gearing for break-in

va_connoisseur
New Member

posted

Just installed the V12 R3 and matching pipe. I will be breaking the engine in this weekend in my Mugen MTX-4R. I have the standard gearing but will be changing it for racing. Should I change the gearing during break-in so that the load will be closer to what the engine will experience? Thanks.

--------------------
http://www.teamkhaos.com

Posts: 3 | From: Virginia | Registered: Jul 2007 | IP: Logged

RB Products - Rody
Administrator

posted

Just use the gearing you are intending to use for racing.

--------------------
Do not forget to check out our FAQ section!

Posts: 5328 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

va_connoisseur
New Member

posted

I was reading the Running-in Procedure and it steps through nine (9) tanks before you begin to tune for performance.

When I am running on the track, tanks 2 and beyond, should I have the body on or off the car? They are not specific. Thanks.

--------------------
http://www.teamkhaos.com

Posts: 3 | From: Virginia | Registered: Jul 2007 | IP: Logged

RB Products - Rody
Administrator

posted

Have the body on the car.

--------------------
Do not forget to check out our FAQ section!

Posts: 5328 | From: Allevard, FRANCE | Registered: Jul 2002 | IP: Logged

UBB.classic™ 6.7.2