Hello, I have a 5port X.12 Rody that runs really well with a NOVA Mega SX-15 Turbo pipe. I have alot of bottom and good top end with this pipe works the best for my setup. Unfortunately I had someone t-bone me on that side and crushed my pipe. So I'm looking for a RB Concept version replacement that will do the same or better then my NM SX-15. One of the guys at my track run the same motor with an X.15 (pipe) none turbo and he said runs ok. I ask him about the X.15 turbo(pipe) and he said it's good on top but not at low end.
Like allways thanks for all your help
best regards Ruf993
Posts: 16 | From: USA NJ | Registered: Nov 2003
| IP: Logged
posted
You should be O.K. with #01751-402 which is a turbo type pipe and the new conical manifold #1751-194
It is correct that the non turbo pipe gives a little better lowend rpm power but in my opinion the turbo-pipe is much better overall if you have the clutch setup well also.
Please do not hesitate to visit the following link
posted
Mr. Rody thanks for your quick reply, The Pipe you recomended do you know the measurements?
I'm thinking the (#01751-402)is a .12 pipe do you think the X.15 pipe turbo or none will be better or worse for my setup. If you have the time can you explain the differance of the two size pipes.
sorry for so much questions I just want to buy the right pip combo cuz i allready made a mistake when i went with RDlogic. I don't feel like wasting more $$ on pipes. I was thinking I should not go wrong with RB pipe since I'm running an RB motor.
thanks again Ruf993
Posts: 16 | From: USA NJ | Registered: Nov 2003
| IP: Logged
posted
This is what I have tested and found working very well, now you are of course always free to us an X15 pipe but I do not think it will work much better if not the same...
The pipes have almost the same external measurements.
UBBFriend: Email this page to someone!
