posted
Im going to adjust my idle-needle on a rotary carb and i read this at the faq:
quote: it must be turned in totally(be sure you position the slide in the open position before you do this, so you do not damage or block the needle in the spray-bar) and then open again 2.5 turns. "
Should i open the throttle, then turn the idle-needle in (clockwise) untill it stops, then turn it out (counterclockwise) 2-3,5 turns ? If i do this the idle-needle will hit the spraybar when im closing the throttle.
Wouldnt it be better to adjust the needle when the throttle is closed?
Posts: 2 | Registered: May 2004
| IP: Logged
UBBFriend: Email this page to someone!
