posted
Rody, i looked in the products section and did a search(tried to anyway). do you make a manifold for 1/10 stadium trucks? thanks, oh and i am going to start to run in my x12 today cant wait and wish me luck LOL
-------------------- Jesus saves Peace, Wesley Posts: 17 | From: Purvis, MS | Registered: May 2004
| IP: Logged
posted
Rody thanks for the email, but i picked up a mugen manifold today. i just started the run in per instructions and man you and whoever else is involved outdid yourselves. the only prob i had was i had to richen the low speed needle to get it to idle, but that was no prob realy. i will finish tomorrow, i am using trinity platinum. while driving around on first tank the temp was at 170-180 degrees, at idle it was around 180-200 anything richer and it would go dead. thanks again
-------------------- Jesus saves Peace, Wesley Posts: 17 | From: Purvis, MS | Registered: May 2004
| IP: Logged
UBBFriend: Email this page to someone!
