I have done a search for this information but it seems to refer to the X-12 and I am after information on the V-12 - I know it might seem daft but I am just wanting to check..
I have seen a post in the forum asking does the x-12 fit in a Tc3 Just want to make sure that the V-12 3 Port Turbo does not have a longer crank.
I have a TC3 RTR and I am looking to buy the Concept V-12 3 Port Turbo SG Crank will it fit and do I need a SG Crank or Standard Crank - I have seen some posts on a Forum in the USA and it says to buy the standard crank and that I would need to cut it down. The engine in the car at the moment is a stock AE 12 Pull start with I think a SG crank (does that mean not threaded all the way along the shaft)
Please help guys I am wanting to buy this today
[ 27. April 2004, 18:26: Message edited by: Exibit ]
Thankyou for your reply, I have done a search to start with as I did not want to waste your time, though I could not find any information on the Concept V-12 fitted to a TC3 - After your reply I thought maybe I should try again so I have searched for "TC3 Concept V-12 Will It Fit
"Then I tried "Will It Fit" The only post I get on the V-12 is the one I listed. I know on the forum rules you would like people to search rather than ask daft questions but the other topics refer to the X-12 not the V-12 Turbo
Indeed you will not find info about the V12 engine, however there is some concerning the X12 engine and the V12 is the follow-up of the X12 and should normally fit.
posted
I have the X12 in my TC3, but the V12 is identical in setup. I had a V12 mounted in my car, but never fired it up. You just need to get the parts that come with a rear exhaust kit NTC3. Its not absolutely nessecary, but I also went with the two speed and lower non-pull engine mounts and flywheel. This will lower your center of gravity in the car. Get the SG shaft and you will have no worries with the two speed.
Posts: 15 | Registered: Apr 2004
| IP: Logged
UBBFriend: Email this page to someone!
