posted
What's up all long time browser,first time poster.I would like to know if anyone has a ballpark setting for low and high speed needles or should I just return needles to factory specs.I just don't seem to be getting the performance out of my motor.To get my motor up to racing temp(about 230 degrees) I have to lean out my high speed needle in way farther than any of my buddies RB's and this affect's the overall performance.I run 30% fuel with a Mcoy 59.My top speed is not that great and my exit speed also lack's punch.What am I doing wrong here,any tip's would be greatly appreciated. Thank's
IP: Logged
diesel
unregistered
posted
I think that you fuel is screwing in up. try using 20% instead.
IP: Logged
posted
Could be the carburetor settings,as well as the tuned pipe as well as many other things why the engine is not performing as you want to. Hard to say with so little info.
posted
I'm running a RB manifold with a RB x-12 pipe.The motor was just broken in and has about 20 or so tank's through Should I go back to stock setting's and retry?
IP: Logged
posted
Toytech- I see you are from the bay area if you are in the SF bay area contact kevin at ace hob bies and he should be able to help you out.
Posts: 5 | From: Asia | Registered: Feb 2003
| IP: Logged
toytech
unregistered
posted
Thank's alot fish.I'm familiar with Ace hobbies.I'll stop by there and see if they can help.
IP: Logged
UBBFriend: Email this page to someone!
![[rol_smiley]](graemlins/rol_smiley.gif)
Should I go back to stock setting's and retry?
![[Big Grin]](biggrin.gif)
Thank's alot fish.I'm familiar with Ace hobbies.I'll stop by there and see if they can help.
